This project was made out of cedar and measures in at around 36 inches wide and 24 inches deep. Each slat was around 1 1/2 inches square and I rounded over all the edges on the router table.
 |
| The finished project in use. |
 |
| Then I setup a jig so holes could be drilled on each end of the board, so a rope could be ran though the holes to hold it together and make it easy to pick up and shake of any dirt or mud. |
|
 |
| Edges then rounded over to provide a smooth surface. |
 |
| First cut to length |
Stay tuned for more updates soon......:-)
****************************************************************
For more information about ordering your own custom board go to:
http://www.splinterswoodworks.com/
No comments:
Post a Comment